|
- Remove door from doorway by removing hinges or by pulling hinge pins.
-
Tip: Position a flat screw driver to catch top of pin and tap upward with hammer.
- Begin with the bottom hinge and work upwards.
- Be sure to support door so it does not fall and cause damage or injury.
|
- Lay the door down on a sturdy work surface.
- Double-Check that you're working on the bottom of the door
|
- Locate the PAWSM Cat Door cut-out template on the back of the box and cut around dotted line.
- Mark a centerline at the bottom of the door.
- Place the template on the door and align it with the center mark on the door.
- Use a pencil to trace the outer edge of the template.
-
Tip: If you tape the template onto the door, it's easier to draw an outline around the entrance hole.
- Carefully, use a Jigsaw or similar cutting tool to cut out the opening.
- Wipe away all dust once cut is complete.
|
|
- Place piece that holds the brush face down onto the opening.
-
Tip: Peel off tape protectors to release adhesion of the double sided tape then press firmly against door for bond.
|
|
- Flip door to the opposite side and overlay second piece so it directly overlaps the piece containing the brush.
- Once again peel off tape protectors and firmly press to secure to door.
- You are now ready to return your door back onto its hinges.
|
|
- The PAWSM self grooming brush can collect a lot of hair.
- In order to clean: pinch the brush from the base of the bristles and pull out.
- To reinsert, simply clip back into place by working from left to right.
|
